Thursday, January 19, 2017

Preliminary Project Sketch



The figure below is the preliminary project sketch for the automated xylophone. 


  • Use 2 mallets to strike xylophone 
  • Mallets will be attached to servo motors to control their vertical movement, allowing them to strike the bars 
  • Servo motors will be attached to belts
  • Belts supported by K'nex structures.
  • Belts control horizontal movement--allow mallet to move up and down the xylophone to play different notes
  • Each mallet will have its own set-up so that the mallets can move horizontally independently of one another
  • The two tracks will be offset slightly so that there is not a gap where no note can be played due to the track ends and motors getting in the way of the mallets getting closer
  • Belts will be controlled by DC motors

No comments:

Post a Comment