Thursday, January 26, 2017

Bill of Materials

The following chart is the bill of materials for this project.


Design Proposal

The following is a sketch of the design.


  • The sound will be produced by mallets striking the xylophone bars
  • The xylophone bars are fabricated out of oak
  • Each mallet will be attached to a different servo motor by tape
  • The servo motors will be attached to the K’nex structure by tape
  • The motors will be powered by individual power supply converters
  • There will be a total of 7 servo motors used to play the xylophone
  • The range is G4-C6, and the motors/mallets will be placed on: G, C, D, E, F, G, and C

Thursday, January 19, 2017

Preliminary Project Sketch



The figure below is the preliminary project sketch for the automated xylophone. 


  • Use 2 mallets to strike xylophone 
  • Mallets will be attached to servo motors to control their vertical movement, allowing them to strike the bars 
  • Servo motors will be attached to belts
  • Belts supported by K'nex structures.
  • Belts control horizontal movement--allow mallet to move up and down the xylophone to play different notes
  • Each mallet will have its own set-up so that the mallets can move horizontally independently of one another
  • The two tracks will be offset slightly so that there is not a gap where no note can be played due to the track ends and motors getting in the way of the mallets getting closer
  • Belts will be controlled by DC motors