- We decided to use solenoids instead of servos as the actuators
- Provide more force
- Don’t need to attach mallets
- Solenoids are attached by hot glue to a metal pole that will be attached to blocks of wood on ends of instrument so that the motors are suspended above bars
- There are a total of 6 solenoids, each one over a different bar
- The decision to switch to solenoids caused several issues, which have put our project behind schedule
- More components in the circuit for solenoids are needed than were needed for servos
- MOSFET’s, resistors, and diodes are now needed due to differences in how the motor takes power
- A different support structure (the metal bar with the motors glued on) had to be designed, built, and implemented, since solenoids are above the bars, whereas the servos were level with the bars.
- Code has to be changed to work with solenoids
- Due to these complications, the instrument is not fully functional yet.
The following is a picture of the xylophone frame with the motor bar sitting on top of the wood supports on the ends. The blocks need to be raised, since the motors are currently too low on the bars.
The following is a picture of a solenoid hot-glued to the metal bar.


