Thursday, February 16, 2017

Week 6 Update


  • We decided to use solenoids instead of servos as the actuators
    • Provide more force
    • Don’t need to attach mallets
  • Solenoids are attached by hot glue to a metal pole that will be attached to blocks of wood on ends of instrument so that the motors are suspended above bars
  • There are a total of 6 solenoids, each one over a different bar
  • The decision to switch to solenoids caused several issues, which have put our project behind schedule
    • More components in the circuit for solenoids are needed than were needed for servos
      • MOSFET’s, resistors, and diodes are now needed due to differences in how the motor takes power
    • A different support structure (the metal bar with the motors glued on) had to be designed, built, and implemented, since solenoids are above the bars, whereas the servos were level with the bars.
    • Code has to be changed to work with solenoids
    • Due to these complications, the instrument is not fully functional yet.


The following is a picture of the xylophone frame with the motor bar sitting on top of the wood supports on the ends. The blocks need to be raised, since the motors are currently too low on the bars.

 The following is a picture of a solenoid hot-glued to the metal bar.

Thursday, February 9, 2017

Week 5 Project Update

Design Change: A long piece of plastic air tubing was sliced in half length-wise so that it can be stretched flat over the frame and nailed down. This will provide a surface on which the bars will rest.



The xylophone:

Plastic tubing:

Thursday, February 2, 2017

Design Changes

The following is an updated sketch of the design.
  • Instead of the motors being supported by a K’nex structure, they will be supported by a wood extension on the xylophone
  • The motors will be taped to the wood extending piece.
  • To limit cost, the motors will all be powered by individual battery packs instead of AC adapters

Thursday, January 26, 2017

Bill of Materials

The following chart is the bill of materials for this project.


Design Proposal

The following is a sketch of the design.


  • The sound will be produced by mallets striking the xylophone bars
  • The xylophone bars are fabricated out of oak
  • Each mallet will be attached to a different servo motor by tape
  • The servo motors will be attached to the K’nex structure by tape
  • The motors will be powered by individual power supply converters
  • There will be a total of 7 servo motors used to play the xylophone
  • The range is G4-C6, and the motors/mallets will be placed on: G, C, D, E, F, G, and C

Thursday, January 19, 2017

Preliminary Project Sketch



The figure below is the preliminary project sketch for the automated xylophone. 


  • Use 2 mallets to strike xylophone 
  • Mallets will be attached to servo motors to control their vertical movement, allowing them to strike the bars 
  • Servo motors will be attached to belts
  • Belts supported by K'nex structures.
  • Belts control horizontal movement--allow mallet to move up and down the xylophone to play different notes
  • Each mallet will have its own set-up so that the mallets can move horizontally independently of one another
  • The two tracks will be offset slightly so that there is not a gap where no note can be played due to the track ends and motors getting in the way of the mallets getting closer
  • Belts will be controlled by DC motors